Welcome: Shenzhen fuyou hardware plastic products co. LTD
Language: Chinese ∷  English
andy@fywjsj.com +86-0755-23725981
   Home > News > Industry new >

Industry new

What if there's no light when the laser cuts
Laser cutting machine cutting quality and precision are very high, but in the use of the process of not laser light out of the case how to do? Let's take a look.
The laser can't tell why it's not working
There is no laser light, in the actual production of the more common manufacturing, in the event of such a failure we do not panic. The main reasons for this phenomenon are as follows:
1. The aging of the lamp leads to the decrease of the laser power
2. The lower the current, the lower the energy output;
3. There is too much dust in the laser, which pollutes the membrane frame and makes it opaque
4. The cooling system is turned on for a long time but the laser power supply is not turned on, which results in ice formation. When the laser power supply is turned on again, no light will appear.
In the daily work, as long as we operate reasonably and sum up the experience, we can effectively avoid the problems in the laser cutting process, finish the cutting task with quality and quantity.
The method to solve the problem that the laser can not produce light
There is no laser light out of the problem do not panic, as long as the steps carefully check the machine can find out the cause, timely repair.
  1
Check whether the water circulation is normal, if the water protection problems can be short water protection use.
  2
Point pre-adjustment to see if the ammeter swing, if not moving may be a power failure.
  3
The laser tube can be replaced and the laser output energy can be reset to solve the problem of low laser power.
  4
Re-adjust the light path to avoid the laser because the light path screw loose light path caused by improper phenomenon.
  5
Clean the membrane frame with anhydrous alcohol, replace the damaged and polluted membrane in time, turn off the power of the machine tool for a period of time and then turn it on again to prevent the icing phenomenon caused by the long-time start-up of the cooling system, all these measures can effectively solve the problem that the laser can not shine.


Scan the qr codeClose
the qr code